You may remember that some time ago I was finishing off some half-completed small projects, among them some Shisha tiles. They use sequins. I’d also been stocking up on sequins for kits (and being seduced by those floral gems). Consequently my mind was in sequin mode, and as it turned out my subconscious mind was as well, as I actually dreamt of sequins one night. Could you, I wondered as I woke up at 2am, suspend a sequin in the centre of a Hardanger cut area? I’ve done it with beads, both single and multiple, so why not sequins? I grabbed the little notebook that lives on my bedside table and scribbled down a few ideas. The following morning it still made sense (not all my night-time scribbles do) although I did realise I’d have to work it slightly differently from my first idea.
Off to my doodle cloth I went, with some floche which happened to be in the needle and a sequin. Here’s what I tried: fasten on and come up in a corner of a cut hole, then thread on a sequin. Down in the fabric at the opposite corner and up in the cut area in the same corner, then take the needle over the diagonal thread.
Go underneath the diagonal, then down through the sequin hole from above. Wrap around the diagonal towards the first corner and go down the fabric. My wrapping wasn’t very even so the sequin isn’t centred, but that’s a matter of practice, and anyway, we’re not done yet . Stretch a thread across the other diagonal (up in the cut hole in one corner, through the sequin and down into the fabric in the opposite corner).
Back along the diagonal as before, wrapping around the thread and going through the sequin, then down into the fabric in the corner again. Voilà, a suspended sequin! And the second diagonal has helped to centre the sequin, even though it was quite a bit off on the first diagonal. (Apologies for the optional cat hair that has enveigled itself into the stitch; I didn’t notice it until I saw the photographs at full size…)
Depending on the size of the sequin this would work on various counts of fabric, I expect. This is a 3mm sequin with 25ct Lugana – 22ct Hardanger would give it a bit more breathing space. With fine fabric you could use a 2mm sequin, I suppose, although I have some in my stash and there isn’t a lot of body to them, so they might get rather lost in the holding threads. 4mm would probably work with 22ct, but as I’ve only got cup sequins in that size I can’t try it out; you really need a flat sequin for this to work. But it needn’t be round, although I would expect it to look most effective with a regular shape. However, if you’d like to try it out with a heart or crescent-shaped sequin do send me a picture to show how it turned out!